JVC 0303MWMMDWJEM - Manual (Page 20)

17
English
1
Press CLOCK/TIMER.
“0:00” appears in the main display with the hour digit
flashing.
2
Press
¢ or 4 repeatedly to adjust the hour.
• When you press and hold the button, the hour digit
changes continuously.
• You can also use the number buttons.
– To adjust the hour to 5, press 5.
– To adjust the hour to 12, press +10, then 2.
– To adjust the hour to 20, press +10, then 10 (or
press +10 twice, then 0).
3
Press SET to set the hour.
The minute digit starts flashing.
• If you want to change the hour again, press
CANCEL.
The hour digit starts flashing again.
Setting the Clock
You can set the clock when the unit is either turned on or in
standby mode.
On the remote control ONLY:
ANGLE AUDIO
1 2 3
4 5 6
7 8 9
10 0 +10
DIMMER
CANCEL
TOP MENU
SET
STROBE
PREV.
DIGITAL
ECHO
KEY
CONTROL 3D PHONIC AHB PRO
NEXT
RETURN
SLOW GROUP SKIP – + SLOW
AUX/MD DVD SELECT FM/AM TAPE
ENTER
MENU CHOICE
COLOR ON SCREEN
PLAY MODE
ZOOM
SUB TITLE
REV. MODE
DIGEST
CLOCK/TIMER
STANDBY/ON
DISPLAY
SLEEP
DVD
LEVEL
A.P.
OFF
SET
PREV. NEXT
GROUP SKIP
CLOCK/TIMER
DISPLAY
CANCEL
4
Press ¢ or 4 repeatedly to adjust the minute.
• When you press and hold the button, the minute digit
changes continuously.
• You can also use the number buttons.
– To adjust the minute to 5, press 5.
– To adjust the minute to 25, press +10, +10, then 5.
– To adjust the minute to 30, press +10, +10, then 10
(or press +10 three times, then 0).
5
Press SET to finish setting the clock.
The built-in clock starts.
To adjust the clock again
Once you have adjusted the clock, you need to press
CLOCK/TIMER repeatedly until the clock setting screen appears
in the main display (the hour digit starts flashing).
When you unplug the AC power cord or if a power
failure occurs
The clock loses its setting and resets to “0:00.” If this happens, set
the clock again.
To turn off the clock indication (power save mode)
On the remote control ONLY:
Press DISPLAY while the unit is in standby mode.
“DISPLAY OFF” appears in the main display and the clock
indication goes off.
To turn on the clock indication, press DISPLAY again
while the unit is in standby mode.
“DISPLAY ON” appears in the main display.
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY.
The clock indication appears in the main display.
To return to the normal display, press DISPLAY again.
EN08_17UX_A7DVD[UF].pm6 03.2.26, 9:24 PM 17