JVC DD-1 - Manual (Page 25)

20
Ba
sic ope
rat
io
ns
If no sound is produced for 3 minutes, the main
unit automatically turns off.
This function is available when a disc/file is
selected as the source.
You cannot use this function when a radio broad-
cast, TV sound or a device connected to the [LINE
IN 1], [LINE IN 2] or [LINE-DIGITAL IN] terminals is
selected as the source.
■When a disc/file is selected as the source
Press [A.STANDBY].
.
• Pressing [A.STANDBY] once again deactivates
the function. (The display window changes to
“A.STANDBY OFF”.)
When playback of a disc/file finishes, the auto
standby function starts a countdown.
When no operation is carried out for 3 minutes, the
main unit automatically turns off.
NOTE
• Leaving the volume at “0” is not the same as
producing no sound, and therefore does not start
the auto standby function.
You can lock the disc tray to prevent the disc from
being ejected.
■When the main unit is turned off
Press 0 while holding down 7 on the
main unit.
• Repeat this step to cancel the disc ejection lock.
(The display window changes to “UNLOCKED”.)
Auto standby function
Activating the auto standby function
“A. STANDBY” indicator
Performance of the auto standby
function
At this time, the “A.STANDBY” indicator
starts flashing.
20 seconds before the main unit turns off,
“A.STANDBY” starts flashing.
Locking disc ejection
Setting the disc ejection lock
For the locations of the remote
control buttons, refer to page 17.
DD-831[B].book Page 20 Tuesday, August 1, 2006 12:09 PM