JVC TH-A10R - Manual (Page 59)

55
Operating JVC’s Audio/Video Components
You can operate JVC’s audio and video components with this system’s remote control, since control signals for JVC components are preset
in the remote control.
IMPORTANT:
To operate JVC’s audio components using this remote control:
• You need to connect JVC audio components through the COMPU LINK-3 (SYNCHRO) jacks (see page 54) in addition to the connections
using cables with RCA pin plugs (see pages 8 and 9).
• Aim the remote control directly at the remote sensor on the center unit.
• If you use the buttons on the front panel or the menu function to choose a source, the remote control will not operate that source. To
operate a source with the remote control, the source must be selected using source selecting buttons on the remote control.
• To operate the cassette deck or MD recorder using the COMPU LINK remote control system, set the source name correctly (see page 17).
• Refer also to the manuals supplied with your components.
To operate JVC’s video components using this remote control:
• Some JVC VCRs can accept two types of the control signals — remote code “A” and “B.” Before using this remote control, make sure that
the remote control code of the VCR is set to code “A.”
• When using the remote control:
– Aim the remote control directly at the remote sensor on each component, not on the center unit.
Primary remote control Secondary remote control
TH-A10R[B]7/f 00.6.27, 0:39 PM 55