Jackson 700 Series - Manual (Page 18)

SIDE BURNER
Open the Side
id and
the
Grate above the
ead.
Burner L
Remove
1 Open the side burner lid and remove the grate over
the burner head.
2 Undo the 2 Phillips head screws that hold the Flame
away from the burner Head.
3 Undo the 3 screws that hold the Burner Head onto
in orifices and place away from the
Natural Gas conversion kit so the orifices will not get
ace the 2 orifices using an approved thread
sealant.
7 Reinstall the Flame Thrower ensuring that the tip is
r Head.
OTE:
Burner h
Thrower (burner ignition) and VERY Carefully move
the Side Shelf base.
4 Remove the 2 ma
mixed up with the new orifices.
5 Repl
6 Reinstall the Burner head using the 3 screws
previously removed.
properly placed inside the bottom of the Burne
Burner Head
screws X 3
Carefully move the Flame Thrower
Flame (Burner ignition) away from the
Burner Head.
Thrower
screws X 2
Undo the 3 screws that hold the Burner Head to the
base plate and carefully move Burner Head off of
the 2 Side Burner orifices
Remove the 2 orifices from the Side
Burner Valve and replace with the
new Natural gas Orifices supplied in
the Natural gas conversion kit
N
These 2 orifices look the same. The smaller size orifice is to be installed in the center outlet of the
ide Burner Gas Valve. And the larger orifice is to be installed on the right hand outlet of the Gas Valve. S
18