Jackson 700 Series - Manual (Page 17)

MAIN BURNER ORIFICES
2 Phillips Screw Driver remove the
y remove the Grease Pan.
Using a 13 mm wrench undo all of the main burner
ices included in
the Natural Gas Conversion Kit.
ces supplied.
5 Before reinstalling the Main Burner tubes, using a # 2 Phillips screwdriver, loosen the screw at
ce of 1/16” OPEN and
6 Reinstall the Main Burners ensuring that the Burner is properly placed over the Main Burner
rear wall.
7 Reinstall the Grease Pan, Upper Flavor Shields and Cooking Grids.
REAR BURNER.
Remove Propane Gas Orifice and
reinstall Natural Gas Orifice
1 Remove the Cooking Grids and Upper Flavor
Shields.
2 Using a #
screw that hold the main burners to the
firebox rear wall.
3 Pull the Grease Pan all the way out. Press on
the clips on the side of the Grease pan and
totall
orifices from the underside of the Display Panel.
Place then aside form any other orif
4 Using an approved thread sealant, replace
the Main Burner Orifices with the NEW
Natural Gas orifi
the Air Shutter on the Main Burner. CLOSE the Air Shutter to a distan
retighten the Air Shutter adjustment screw.
orifice and reinstall the Main Burner screw on the firebox
river undo the 4
2 Once the Cover has been
using an approved thread sealant.
4.
NO
1 Using a # 2 Phillips
screwd
screws that hold the Back
Cover plate to the Inner
Hood.
removed use a 7 mm
wrench to remove the Rear
Burner Orifice from the
Rear Burner.
3. Install the new Rear Burner orifice
Reinstall the Rear Burner Cover Plate using the 4 screw previously removed.
TE: There is NO air adjustment required when converting the rear burner from Propane Gas to Natural
as. G
Remove the 4 screws that hold the Back
iver Cover plate using a # 2 Phillips screwdr
Undo the Rear Burner Orifice using a
7 m
m wrench.
rifice
using an approved thread sealant.
Reinstall the new Natural Gas O
17