JVC SP-UXP7 - Manual (Page 17)

– 14 –
Playing Back CDs (CD/CD-R/CD-RW)
This unit has been designed to playback the following CDs:
• CD
• CD-R
• CD-RW
Continued use of irregular shape CDs
(heart-shape, octagonal, etc.) can damage the
unit.
General Notes
In general, you will have the best performance by keeping
your CDs and the mechanism clean.
• Store CDs in their cases, and keep them in cabinets or on
shelves.
• Keep the unit’s disc tray closed when not in use.
When playing a CD-R or CD-RW
User-edited CD-Rs (CD-Recordable) and CD-RWs
(CD-ReWritable) can be played back only if they are already
“finalized.”
• You can play back your original CD-Rs or CD-RWs
recorded in music CD format. (However, they may not be
played back depending on their characteristics or recording
conditions.)
• Before playing back CD-Rs or CD-RWs, read their
instructions or cautions carefully.
• Some CD-Rs or CD-RWs may not be played back on this
unit because of their disc characteristics, damage or stain
on them, or if the player’s lens is dirty.
• CD-RWs may require a longer readout time. (This is
caused by the fact that the reflectance of CD-RWs is lower
than for regular CDs.)
Playing Back the Entire CD — Normal Play
1
Press CD
0 on the remote control
(or
0 on the CD player section).
The unit automatically turns on and the disc
tray comes out.
2
Place a disc correctly on the circle of the disc
tray, with its label side up.
• When using a CD single (8 cm), place it on the inner
circle of the disc tray.
3
Press CD
3/8.
The disc tray automatically closes and the first
track of the CD starts playing.
• The CD automatically stops when the last track of the
CD has finished playing.
To stop playing, press 7.
To remove the disc, press CD 0 on the remote control (or 0
on the CD player section).
• If the CD cannot be read correctly (because it is scratched, for
example)
“00 0000” appears on the display.
• If no CD is inserted
“NO DISC” appears on the display.
• If an unreadable CD-R or CD-RW is inserted
“BLANK CD” appears on the display.
DO NOT try to open or close the CD tray by hand
as it will be damaged.
Basic CD Operations
While playing a CD, you can do the following operations.
To stop playing for a moment
Press CD
3/8.
While pausing, the elapsed playing time
flashes on the display.
To resume playing, press CD
3/8 again.
To go to another track
Press MULTI KEY > / MULTI KEY < or
¢ / 4 repeatedly before or during
playback.
• MULTI KEY > or
¢ :
Skips to the beginning of the
next or succeeding tracks.
• MULTI KEY < or 4 :
Goes back to the beginning of
the current or previous tracks.
To locate a particular point in a track
During play, press and hold
¢ or 4.
•
¢ : Fast-forwards the tracks.
• 4 : Fast-reverses the tracks.
CD
Track number Elapsed playing time
CD
CORRECT INCORRECT
Continued
MULTI KEY
CD
Total track number Total playing time
EN14-17.UX-P7R[B] 01.3.14, 1:29 PM 14