JVC SP-UXP7 - Manual (Page 13)

– 10 –
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich, full bass at
low volume. This function only affects the playback sound,
but does not affect your recording.
When using the remote control, press
AHB PRO LEVEL + to increase the bass
sound or press AHB PRO LEVEL – to
decrease it.
When using the unit, turn AHB PRO + / –
clockwise (+) to increase the bass sound or
counterclockwise (–) to decrease it.
• The bass sound level can be adjusted in 5 steps (“BASS 1”
to “BASS 5”). The BASS indicator also lights up on the
display.
To cancel the effect, press AHB PRO LEVEL – on the
remote control (or turn AHB PRO + / – counterclockwise on
the unit) until “BASS 0” appears on the display. The BASS
indicator goes off.
Selecting the Sound Modes
You can select one of the 4 preset sound modes. This function
only affects the playback sound, but does not affect your
recording.
To select the sound modes, press
SOUND MODE on the remote control (or
SOUND on the unit) until the sound mode you
want appears on the display. The SOUND
indicator also lights up on the display.
• Each time you press the button, the sound modes change as
follows:
ROCK: Gives a heavy sound. Boosts low and high
frequency.
POP: Good for vocal music.
CLASSIC: Good for classical music.
JAZZ:
Gives a feeling of live atmosphere. Good for
acoustic music.
FLAT: The sound mode is canceled. The SOUND
indicator goes off.
Adjusting the Volume
You can adjust the volume level only while the unit is turned
on. The volume level can be adjusted between “VOLUME 0”
and “VOLUME40.”
When using the remote control,
press VOLUME + to increase the
volume or press VOLUME – to
decrease it.
When using the unit, turn VOLUME + / –
clockwise (+) to increase the volume or
counterclockwise (–) to decrease it.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, a
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source next time.
REMEMBER you cannot adjust the volume level
while the unit is on standby.
Selecting the Display Brightness
You can change the display brightness only while the unit is
turned on.
To change the display brightness, press
DIMMER on the remote control.
• Each time you press the button, the display
dims and brightens alternately.
BASS
SOUND
FLAT
ROCK POP
CLASSIC JAZZ
AHB PRO
LEVEL
VOLUME
SOUND
MODE
VOLUME
(Canceled)
SOUND DIMMER
AHB PRO
EN01-13.UX-P7R[B] 01.3.14, 1:27 PM 10