JVC SP-UXP7 - Manual (Page 14)

– 11 –
Listening to FM and AM (MW/LW) Broadcasts
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes in
the previously tuned station (either FM or AM
— MW/LW).
• Each time you press the button, the band
alternates between FM and AM (MW/LW).
2
Press and hold
¢ or 4
for more than 1 second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo, the ST (stereo)
indicator lights up.
To stop searching, press ¢ or 4.
When you press ¢ or 4 briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive
or noisy, press FM MODE on the remote control
so that the MONO indicator lights up on the
display. Reception improves.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In this stereo mode, you can
hear stereo sounds when a program is broadcasted.
Presetting Stations
You can preset 30 FM and 15 AM (MW/LW) stations —
using either automatic presetting or manual presetting.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
To preset stations automatically
— Automatic Presetting
You need to preset stations separately for the FM and AM
(MW/LW) bands.
On the remote control ONLY:
1
Press FM/AM to select the band.
• Each time you press the button, the band
alternates between FM and AM (MW/LW).
2
Press and hold AUTO PRESET for
more than 2 seconds.
Local stations with strong signals are searched
and stored in memory automatically.
When automatic presetting is over, the station
stored in preset number 1 is received.
3
Repeat steps 1 and 2 to store stations for the
other band.
When you cannot automatically store stations you want
Stations with weak signals cannot be detected with this automatic
presetting. To store such a station, use the manual presetting.
To preset stations manually — Manual Presetting
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
On the remote control ONLY:
1
Tune in the station you want to preset.
• See “Tuning in a Station.”
2
Press SET.
3
Press MULTI KEY > or
MULTI KEY < to select a preset
number.
4
Press SET again.
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
On the remote control ONLY:
1
Press FM/AM.
The unit automatically turns on and tunes in
the previously tuned station (either FM or AM
— MW/LW).
• Each time you press the button, the band
alternates between FM and AM (MW/LW).
2
Press MULTI KEY > or
MULTI KEY < to select a preset
number.
FM MODE
FM/AM
FM/AM
AUTO
PRESET
FM/AM
MULTI KEY
MULTI KEY
SET
SET
EN01-13.UX-P7R[B] 01.3.14, 1:27 PM 11