JVC 0797TOV*UN*SN - Manual (Page 20)

20
EN
MENU
OFF
P
L
A
Y
A
M
5S
OFF
PLA
Y
A
M
5S
1 SELECT OPERATION MODE
Turn the Power Dial to “PLAY” while pressing
down the lock button located on the dial.
2 PULL OUT VIEWFINDER OR OPEN
LCD MONITOR
Pull out the viewfinder fully or open the LCD
monitor to approx. 90° degrees.
•The lens cover opens, the power lamp comes
on.
3 START SEARCH
Press 4/6, then press 2 or 3. Watch in the
viewfinder or the LCD monitor for the spot
where you want to begin recording.
4 ENGAGE STILL MODE
Once you find the spot at which you want to
start recording, press 4/6 to engage the Still
mode.
5 START RECORDING
Turn the Power Dial to any operation mode
except “PLAY” and “OFF”, then press START/
STOP.
•Start recording from a point prior to the end
of the last recording. A few seconds of the
end of the last recording will be erased.
NOTE:
If you start recording from the end of the previous
recording leaving no blank space, there may be
situations where a clean transition is not possible.
Recording From The Middle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing
back the recording previously made (without taking the tape out between recordings), perform this
procedure.
RECORDING (Cont.)
REW STOP
PLAY/PAUSE
Lock button
FF
Power Dial
START/STOP Button