JVC GR-DVL610SH User Manual

Page 63

2
3
4
5
6
7
8

– – : – – ~

~
~
~
~
~
~
~

– – : – –

0 : 00

– –

TOTAL

CODE

T I ME

OUT

MODE

FADE/WIPE

EFFECT

EDIT IN/OUT

CANCEL

REW

FF
PLAY

R.A.EDIT
ON/OFF

SELECT SCENES

Point the remote control at the camcorder’s remote
sensor. Press PLAY (4) and then press R.A.EDIT ON/
OFF on the remote control.
The Random Assemble Editing Menu appears.

If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE on the remote control.
•Cycle through the effects by pressing repeatedly,

and stop when the one you want is displayed.

•You cannot use a Picture Wipe/Dissolve at the

beginning of Programme 1.

At the beginning of the scene, press EDIT IN/OUT on
the remote control. The Edit-In position appears in
the Random Assemble Editing Menu.

At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random Assemble
Editing Menu.

If using a Fade/Wipe at the end of the scene, press
FADE/WIPE.
•Cycle through the effects by pressing repeatedly,

and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out

point, the effect is automatically applied to the
following Edit-In point.

•You cannot use a Picture Wipe/Dissolve at the end

of the last scene.

•When you use Fade/Wipe effects, that time is

included in the total time (this does not apply to
Picture Wipe/Dissolve).

If using Playback Special Effects, press EFFECT
(

੬

pg. 59).

Repeat steps 6 through 9 to register additional scenes.
•To change previously registered points, press

CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.

•If you are not using Fade/Wipe or Programme AE

with special effects, repeat steps 6 and 7 only.

NOTES:

● When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between

them.

● If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be

cancelled and editing will not take place.

● If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in

the edited version.

● Since time codes register time only as accurately as seconds, the time code total time may not match the

total programme time exactly.

● Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

● If you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Dissolve

or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next
Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during
recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.

● It is not possible to use Fade/Wipe effects and Programme AE with special effects during Random Assemble

Editing using a DV cable.

Random Assemble
Editing Menu

Programme

Remote sensor

CONTINUED ON NEXT PAGE