JVC HR-E939EG - Manual (Page 29)

EN
29
Your remote control can operate the basic functions of your TV
set. In addition to JVC TVs, other manufacturer’s TVs can also
be controlled by setting the appropriate switch on the remote
control.
Before you start . . .
● Turn on the TV using its remote control.
● Set the remote control’s TV/VCR switch to TV.
NOTE:
If your TV is a JVC, you don’t have to set the code in step 1. Go
to step 2.
Multi-Brand
Remote
Control
SET TV BRAND CODE
1
Refer to the chart below. While holding down OPER-
ATE, enter your TV’s brand code using the NUMBER
keys, then press STOP.
● You don’t have to repeat this step until you replace
your remote control’s batteries.
TRY OPERATING TV
2
Press OPERATE on the remote to turn the TV off. If it
goes off, try other operations.
● The OPERATE button, TV/VIDEO button, TV PROG.
+/– button, TV VOL. %fi button and MUTE button on
the remote can all be used to operate the TV.
● To return the remote to video recorder control, set its
TV/VCR switch to VCR.
IMPORTANT
Although the provided remote control unit is compatible with
JVC televisions, as well as many other models, it may not work
with your TV, or in some instances, may have limited function
capability.
Control Your TV Using Addi-
tional Buttons
The NUMBER keys on the remote can also be used to select
the TV’s channel by setting the remote control to the TV mode.
1 Set the TV/VCR switch to TV.
2 Use the NUMBER keys, and the DIGIT ENTRY ( )
button, the PUSH JOG button, the DISPLAY button or
the OK button to select the TV’s channel.
● With televisions under Code 01, 03, 04, 06, 07, 10 or 11,
the DIGIT ENTRY button corresponds to the 1-digit/2-
digit entry switching button (often labelled – /– –) of your
TV’s remote control.
● With televisions under Code 01, 08 or 09, the PUSH JOG
button corresponds to the 10 + button, and the PUSH
JOG button corresponds to the 20 + button of your
TV’s remote control.
● With televisions using Code 09, the DISPLAY button
corresponds to the 30 + button.
● With televisions using Code 06, the OK button corre-
sponds to the ENTER button of your TV’s remote control.
NOTE:
The way these buttons are used is determined by your TV.
Use these buttons as instructed for your TV’s remote
control.
%
%
CODE TV BRAND NAME
01 JVC
02 BRANDT, NORDMENDE, SABA, TELEAVIA,
TELEFUNKEN, THOMSON
03 FERGUSON
04 PHILIPS
05 BLAUPUNKT, GRUNDIG
06 SONY
07 PANASONIC
08 GRAETZ, ITT, LUXOR, SALORA, SELECO
09 MIVAR
10 HITACHI
11 TOSHIBA
12 MITSUBISHI
13 FINLUX
14 NOKIA
1 2
4 5
3
6
8
0
7 9
2
1
3
NUMBER
TV PROG.
OK
TV/VCR
TV/VIDEO
STOP
PUSH JOG
TV VOL. %fi
DIGIT ENTRY
MUTE
OPERATE
DISPLAY
REMOTE CONTROL