JVC HR-E939EG - Manual (Page 27)

EN
27
ENTER PROGRAMME STOP
TIME
4
Press STOP +/– to enter the time you want recording to
stop.
● If you are using the Illumi-Guide feature, the following
buttons remain lit: START +/–, STOP +/–, DATE +/–,
and TV PROG. +/–.
ENTER PROGRAMME DATE
5
Press DATE +/–. (The current date appears on screen.
The date you enter appears in its place.)
● If you are using the Illumi-Guide feature, the following
buttons remain lit: START +/–, STOP +/–, DATE +/–,
and TV PROG. +/–.
ENTER CHANNEL
POSITION
6
Press TV PROG. +/–.
● If you’re not receiving
PDC/VPS, press NUMBER
key “7” to set
to
"OFF" (
੬
pg. 28).
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: START +/–, STOP
+/–, DATE +/–, and TV PROG. +/–.
SET TAPE SPEED
7
Press SP/LP to set the tape speed.
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
● Repeat steps 1–8 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
9
Press TIMER.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday–Friday).
– P1 –
START STOP
21 : 00 = 22 : 00
SP ON
DATE TV PROG
25. 12 1
ARD
[+/ –] =
SP
M D
8
• •
• • • • • •
• • • • •
• • • • • •
• • •
1 2
4 5
3
6
8
0
7 9
2
1
3
WEEKLY
TIMER
SP/LP
SP/LP
DAILY
TV PROG.+/–
DATE+/–
NOTES:
● To timer-record from a satellite tuner connected to your
recorder's AV2 IN/DECODER connector, press TV PROG. +/–
in step 6 above to set the channel position to "AUX2".
● You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen and "FULL"
appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
੬
pg. 28).
TIMER
:PDC/VPS
STOP+/–
START+/–
OK