JVC HR-E939EG - Manual (Page 15)

EN
15
Names of
special-effects
playback
Reverse Forward
Search Play Slow-Motion *Still Slow-Motion Play Search
-9x -7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x 9x
-7x -3x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 5x 9x
Orange Green Red Green Orange
Audio is output.
Audio is not Audio is Audio is not
Audio is output.
output. output. output.
TimeScan
* Still mode cannot be engaged using the remote control's PUSH JOG button. In the Still mode, the TIME
SCAN indicator does not light even though you can hear TimeScan audio.
● The VCR's TimeScan indicator lights during TimeScan.
● The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
● To resume normal playback, press PLAY.
● When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change depending on how far it is turned.
● Picture may be distorted at the position where the recording speed is switched.
● The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
● Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
● Picture may appear distorted in comparison to normal playback.
● In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
● TimeScan sound quality will differ in comparison to normal playback.
● When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
● TimeScan does not work with NTSC playback. Picture will be monochrome with an LP-recorded MESECAM tape during
TimeScan.
If you don't want to hear TimeScan audio, set the TIME SCAN AUDIO swtich on the recorder to OFF.
Speed LP
Speed SP
Recorder's Time
Scan shuttle
indicator
Audio output