John Deere GREENSTAR BZ100157 - Manual (Page 8)

Installation Instructions
OUCC002,000233C –19–12OCT06–1/2
Modify High Arc Spout
ZX1039636
–UN–12JUL06
ZX1039637
–UN–12JUL06
ZX1039638
–UN–12JUL06
ZX1039639
–UN–12JUL06
ZX1039640
–UN–12JUL06
A—Fixing Screws
B—Fixing Screws
C—Template Z103666
D—Area to Cut
E—Drilling Holes
F—Brackets Z103667
On machines with old high arc type spout, proceed as
follows to install NIR sensor brackets:
1. On both sides of the spout, release the side wear plate
fixing screws (A) and rear wear plate fixing screws (B).
Remove and discard rear wear plate. Remove both
side wear plates.
2. Install template Z103666 (C) over spout as shown
using original hardware (A). Pull up template Z103666
(C) to set it correctly in position then tighten fixing
screws (A).
3. Mark area (D) to cut a hole 102 mm (4.01 in.) diameter
then drill two holes 11x20 mm (0.43x0.78 in.) at
locations (E).
4. Install brackets Z103667 (F) on template Z103666 (C)
with four screws 19M7865 M8X16 and flange nuts
14M7298. Make sure brackets (F) are in contact with
spout sides then weld at front and rear of the brackets
(F) (see arrows) on spout.
IMPORTANT: Grind spout sides at locations where
weld will be carried out.
5. Remove template Z103666 (C) then finalize welding
process on top of brackets Z103667 (F) (see arrow).
Z103757 (13DEC06)
6
Installation Instructions
011507
PN=8
Continued on next page