John Deere GREENSTAR BZ100157 - Manual (Page 18)

Installation Instructions
OUCC002,00021CA –19–18NOV06–1/8
Install Job Computer AZ59199 and Wiring Harness AZ101120
ZX1037466
–UN–13SEP05
ZX1037467
–UN–13SEP05
ZX1037468
–UN–13SEP05
ZX1037469
–UN–13SEP05
A—Job computer AZ59199
B—Screws M8x60
C—Main connector
D—Wiring harness AZ101120
E—A7 CAN bus terminator
F—Connector
G—X27 Connector
H—X30 Connector
I—AZ71569 Connector
1. Install job computer AZ59199 (A) as shown on the
bottom left side of load center with three screws M8x60
(B) using existing nuts in the wall.
2. Connect main connector (C) of wiring harness
AZ101120 (D) to job computer (A).
3. Disconnect A7-CAN bus terminator (E) located near
the board A3. Connect CAN bus terminator (E) to
relevant connector (F) of wiring harness AZ101120 (D),
then connect wiring harness AZ101120 to terminator
(E) original connector as shown.
4. Locate free connectors X27 (G) and X30 (H), then
connect them to the relevant machine wiring harness
free connections using parts of connector AZ71569 (I)
and following tables:
X27 Connector AZ71569 Pin Connections
Pin Number Wire
Pin #1 .......................................... 552C
Pin #2 .......................................... 974
Pin #3 .......................................... 975
Pin #4 .......................................... 050B
Pin #5 .......................................... not used
Pin #6 .......................................... not used
Z103757 (13DEC06)
16
Installation Instructions
011507
PN=18
Continued on next page