JVC HR-DD855EK - Manual (Page 34)

34
Audio dubbing replaces the normal audio sound of a previously
recorded tape with a new soundtrack.
Audio Dubbing
Original sound
AUDIO OUT
Audio mixer
MAKE CONNECTIONS
1
Connect an audio component to the AUDIO L + R
connectors on the recorder's front panel.
● When connecting monaural equipment, use only the
recorder's AUDIO L connector.
SET INPUT MODE
2
Press NUMBER key "0" and/or TV PROG so that "F-1"
appears in place of a channel number.
LOCATE START POINT
3
Press PLAY to start playback of the tape in your
recorder, and press PAUSE when you find the point
where you want to start dubbing.
ENGAGE AUDIO DUBBING
4
Press A. DUB.
● It is possible to take the original sound recorded on
the tape in your recorder and mix it with other
sounds from a microphone, CD player etc. To
perform this audio dubbing with audio mixing,
connect as in the diagram on the left.
● Your recorder enters the Audio Dubbing Pause mode.
(" " blinks, " " and " " light up on the front display
panel.)
● To perform audio dubbing with audio mixing, press
AUDIO on the remote control to select " + (L+R)"
at this point.
* Audio dubbing with audio mixing is not possible if
you're using a monaural audio component, or if
you don't have an audio mixer.
Audio-dubbed tape
CD Player etc.
Mixer
output
Pre-recorded tape Normal audio track
Video/Hi-Fi audio
track
PLAY
PAUSE
A. DUB
CD Player etc.
STOP
TV PROG