Jet Tools 708315BTA - Manual (Page 17)

17
Optional Left Table Support
Models BTB, BTC and LSA
Referring to Figure 17:
Table saw models BTB, BTC and LSA do not come
with a left extension table. However the rear
support assembly (A) can be removed and used as
a left table support if needed. To do this:
1. Loosen two lock knobs underneath the back of
the table that secure the rear support
assembly (A).
2. Remove the rear support assembly by sliding it
back (B).
3. Turn the assembly over so that the flat side of
the rail is on top (C) and the two notches (D)
are on the bottom.
4. Loosen the two lock knobs (E) located on the
left side of the table.
5. Install the rear support assembly by inserting
inserting the extension rods into the two
mounting holes on the left side of the table (F).
Remember that the notches (D) are on the
bottom.
7. Tighten the lock knobs.
Handwheel Handle
All Models
Referring to Figure 18:
1. Insert a 5mm hex wrench (A) in the end of the
handle (B) into the socket head cap screw.
2. Thread into the handwheel (E) until almost
tight.
While still maintaining a hold on the hex
wrench (A):
3. Tighten the hex nut (C) with a 10mm wrench
(D) against the handwheel (E) so that the
handle (B) is secure, but its rotation is still
allowed during operation.
Figure 17
Figure 18