Jet Tools 708315BTA - Manual (Page 15)

15
Sliding Extension Wing
Right Wing used on Models BTC, LSA and LSB
Left Wing used on Model LSB
Assembly (if required)
Refer to Figure 14.
For saws using the sliding extension wings, two
extension rods (C) need to be assembled before
mounting to the table. Assembly for the right
extension wing (A), identified by no rule on the rail
(J), is described below. Assembly for the left wing
is the same.
1. Using two 10mm wrenches, remove the lock
nut (B) from the extension rods (C and D).
2. Turn the extension wing (A) over so the JET
logo lays face down and the mounting holes
and tabs (F,K) are visible.
3. Insert the rods (D) through the mounting holes
on the extension wing (F) and tab (K)
The threaded end of the rod (D) should
protrude through the hole in the tab (K).
4. Place hex nuts (G) on the threaded ends of the
extension rods (D), leaving loose enough to
rotate the rods by hand.
5. Rotate the extension rods so that the threaded
holes, located near the ends away from the
extension table, are in line with the top of the
extension table.
6. Secure the extension rods with two 10mm
wrenches, placing one wrench on the hex nut
and the other on the flat indents of the rod.
7. Repeat the above steps for the left extension
wing for models that include it.
Mounting the Right Extension Wing Assembly
Models BTC, LSA and LSB – the right extension
wing looks like A in Figure 15
Referring to Figure 15:
1. Select the right extension table (A), which is
identified by no scale on the guide rail (B).
2. Mount the extension table by sliding the
extension rods into the mounting holes (C) on
the right side of the saw table. The lock
knobs (D) may need to be loosened.
3. From the bottom of the table, thread an M4x8
pan head screw (G) into the hole near the end
of the rear extension rod (E
3
). This is the rod
closest to the rear extension (F
1
and F
2
).
4. Tighten the lock knobs (D).
Figure 14
Figure 15