IBM TotalStorage DS6000 Series - Manual (Page 371)

Appendix B. Using the DS6000 with iSeries 347
When you get to the point where you will select the volumes to be added, you will see a panel
similar to that shown in Figure B-27. Multipath volumes appear as DMPxxx. Highlight the
disks you want to add to the disk pool and click Add.
Figure B-27 Adding a multipath volume
The remaining steps are identical to those in “Adding volumes to an Independent Auxiliary
Storage Pool” on page 334.
Note: For multipath volumes, only one path is shown. In order to see the additional paths,
see “Managing multipath volumes using iSeries Navigator” on page 349.