Integra DTR-7.6/6.6 - Manual (Page 55)

55
Common Functions —Continued
With the sleep timer, you can set the AV receiver so that
it turns off automatically after a specified period.
To cancel the sleep timer, press the [Sleep] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [Sleep]
button. Note that if you press the [Sleep] button while the
sleep time is being displayed, you’ll shorten the sleep
time by 10 minutes.
For private listening, you can connect a pair of stereo
headphones (1/4-inch phone plug) to the AV receiver’s
Phones jack.
Notes:
• Always turn down the volume before connecting your
headphones.
• The speakers are turned off while the headphones plug
is inserted in the Phones jack. (The Zone 2 speakers
are unaffected.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it was set to Mono, Ste-
reo, or Direct, in which case it stays the same.
You can display various information about the current
input source as follows.
The following information can typically be displayed:
*If the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling fre-
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed.
On the DTR-7.6, if the input signal is multichannel
PCM, the sampling frequency and signal format will be
displayed. Information is displayed for about 3 seconds,
then the previous display reappears.
Interpreting Surround Channel Information
A: The number of front channels (front left, front right,
and center).
B: The number of surround channels (surround left and
surround right). If there’s surround back channel
information, this number will be 3.
C: LFE channel for subwoofer (1 means yes).
Using the Sleep Timer
Press the remote controller’s
[Sleep] button repeatedly to
select the required sleep time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about 5 sec-
onds, then the previous display reap-
pears.
Using Headphones
SLEEP indicator
Displaying Source Information
Press the [Display] button
repeatedly to cycle through the
available information. Remote
controller
AV receiver
Input source &
volume
Signal format*
or sampling
frequency
Input source &
listening mode
A B C