Integra DTR-7.6/6.6 - Manual (Page 31)

31
Connecting Your Components —Continued
• With connection , you can listen to and record audio from the CD player and listen in Zone 2.
• To connect the CD player digitally, use connection or . (For Zone 2, use and , or and .)
The AV receiver’s PHONO IN is for use with a moving
magnet (MM) type cartridge.
Use an analog audio cable to connect the AV receiver’s
PHONO IN L/R jacks to the audio output on your turn-
table.
Notes:
• If your turntable has a ground wire, connect it to the
AV receiver’s GND screw. With some turntables, con-
necting the ground wire may produce an audible hum.
If this happens, disconnect it.
• If your turntable has a moving coil (MC) type car-
tridge, you’ll need a commercially available MC head
amp or MC transformer. Connect your turntable to the
head amp or transformer, and connect that to the AV
receiver’s PHONO IN L/R jacks.
• You can also use a phono equalizer to connect a turn-
table with an MC-type cartridge. See the phono equal-
izer’s manual for details.
Connecting a CD Player
Connection AV receiver Signal flow CD
CD IN L/R
⇐
Analog audio L/R output
DIGITAL COAXIAL IN 2
⇐
Digital coaxial output
DIGITAL OPTICAL IN 3
⇐
Digital optical output
Connecting a Turntable
COAXIAL
IN 2
COAXIAL
OUT
AUDIO
OUT
L R
OPTICAL
OUT
OPTICAL
IN 3
L
R
IN
CD
b
c
a
Step 1:
Choose a connection that matches your CD player (
, , or ), and then make the connection. a b c
CD player
Connect one
or the other
a
b c a b a c
a
b
c
L
R
AUDIO
OUTPUT
PHONO
R
L
IN