Integra DTR-7.6/6.6 - Manual (Page 38)

38
First Time Setup
This section explains the settings that you need to make
before using the AV receiver for the very first time.
With the supplied speaker setup microphone, the Auto-
matic Speaker Setup function can measure the test tone
output by each speaker and automatically determine the
number of speakers connected, the crossover frequency,
the distance from each speaker to the listening position,
and so on. Before using this function, connect and posi-
tion all of your speakers.
Automatic Speaker Setup
1 Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
3, 4
1
2, 5
Note: If any of your speakers is 4 ohms, change the
minimum speaker impedance setting before running
the automatic speaker setup (see page 44).
2 Put the speaker setup micro-
phone in the listening position.
Notes:
• Make sure the microphone is hori-
zontal.
• If there’s an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD.
• Positioning the microphone close to
where your ears would normally will
provide better results. You can adjust
the height of the microphone by
using a tripod or level table.
Connect the setup microphone to
the Setup Mic jack.
Notes:
• If the AV receiver was previously
muted, it will be unmuted.
• Automatic speaker setup cannot be
performed while a pair of head-
phones is connected.
Microphone
Auto Speaker Setup
========================
Push Enter:Start
Caution! Loud sound.