Integra DTR-7.6/6.6 - Manual (Page 36)

36
Connecting Your Components —Continued
The AV receiver has AC outlets on its rear panel that can
be used to connect the power cords of other components
that you intend to use with the AV receiver. These com-
ponents can then be left turned on so that they turn on
and off as and when the AV receiver is turned on and set
to Standby.
Caution:
• Make sure that the total capacity of the components
that you connect to the AC OUTLETS does not exceed
the stated capacity (e.g., TOTAL 120 W).
Note:
• Integra components connected via should be con-
nected directly to a wall outlet, not an AC OUTLET on
the AV receiver.
• The number of AC OUTLETS, socket type, and total
capacity depends on the country in which you pur-
chased the AV receiver.
This port is for connecting the AV receiver to home auto-
mation equipment and external controllers.
Notes:
• Before connecting the power cord, connect all of your
speakers and AV components.
• Turning on the AV receiver may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different branch circuit.
• Do not use a power cord other than the one supplied
with the AV receiver. The supplied power cord is
designed exclusively for use with the AV receiver and
should not be used with any other equipment.
• Never disconnect the power cord from the AV receiver
while the other end is still plugged into a wall outlet.
Doing so may cause an electric shock. Always discon-
nect the power cord from the wall outlet first, and then
the AV receiver.
Connecting the Power Cords of Other
Components
AC OUTLETS
AC 120 V 60 Hz
SWITCHED
TOTAL 120W 1A MAX.
Connecting the RS232 Port
Connecting the Power Cord
1 Connect the supplied power cord
to the AV receiver’s AC INLET.
2 Plug the power cord into an AC
wall outlet.
The Standby indicator lights up.