IBM S544-5285-01 - Manual (Page 187)

APK413S ATTEMPTED {
OPEN ¦ CLOSE ¦ READ ¦ WRITE} OF
RESOURCE FILE 'ddname', RESOURCE
MEMBER NAME 'member name' FAILED.
RETURN CODE nnnn.
Explanation: An attempt to open, close, read, or write
a resource failed. This message indicates that an
abnormal occurrence has taken place in the called
module. This message is informational and further
action will take place in higher level modules if required.
System Action: None; this message is for information
only
User Response: See the accompanying message to
determine a response.
System Programmer Response: No response is
necessary.
APK414I THE FOLLOWING PARAMETERS WILL
BE USED FOR THIS RUN:
Explanation: This message is issued before APK415I,
APK416I, and APK417I to begin the listing of the
parameters to be used for this run.
System Action: None
User Response: No response is necessary.
System Programmer Response: No response is
necessary.
APK415I parameter = value.
Explanation: For this run, the parameter listed has
been used with the associated value.
System Action: None
User Response: No response is necessary.
System Programmer Response: No response is
necessary.
APK416I THESE { DATA SETS ¦ FILETYPES } HAVE
BEEN SPECIFIED FOR library name.
Explanation: This message is issued before message
APK417I and shows the DD name or file type for a
specific resource type contained in the ACIF parameter
file.
System Action: None
User Response: No response is necessary.
System Programmer Response: No response is
necessary.
APK417I { DATASETNAME ¦ FILETYPE }: name
Explanation: This message follows APK416I and lists
the name of the data set or file type for a particular
resource type.
System Action: None
User Response: No response is necessary.
System Programmer Response: No response is
necessary.
APK418S THE MAXIMUM RECORD ID WAS
EXCEEDED.
Explanation: The current job contains more than
999 999 999 documents.
System Action: ACIF terminates.
User Response: Break the job up into a smaller
number of documents.
System Programmer Response: No response is
necessary.
APK419S USER {INPUT ¦ OUTPUT ¦ RESOURCE }
EXIT program RETURNED CODE nnnn.
Explanation: The indicated user exit program has
returned a non-zero return code.
System Action: ACIF terminates.
User Response: Correct the error in the exit program
and resubmit the job.
Return Codes
0 - Successful
1 - Permanent I/O
error
2 - Specified number
of bytes is zero or
negative
3 - Invalid data buffer
address
4 - Address not word
aligned
6 - Invalid FILE_CB@
7 - Invalid MODE
parameter
8 - Data record longer
than LRECL or
buffer
9 - File is not
supported type
10 - Storage
allocation/deallocation
failed
11 - Invalid record
number
12 - End of file
detected
13 - Disk is full
14 - RECFM invalid
20 - Invalid file id
28 - File not found
51 - Length exceeds
maximum
310 - File format invalid
Chapter 10. ACIF Messages for OS/390, MVS, VM, and VSE 167