Hm-162e installation – Icom IC-M505 User Manual
Page 69
63
9
CONNECTIONS AND MAINTENANCE
9
r Return the cables and screws to the original position.
• Be sure not upside down the flat cable.
CAUTION:
• When re-assembling the case and tightening the screws,
you must keep the specified torque (0.5±0.07 N.m). Oth-
erwise the transceiver may be damaged (torque too high)
or lose waterproof efficiency (torque too low).
• When uninstalling the optional unit, remove it vertically.
Wiggling the unit from side to side may damage the op-
tional unit's connector.
■ HM-162E installation
The optional HM-162E should be installed to the transceiver
using the supplied connection cable.
The connector of the connection cable can be installed into a
cabinet, wall, etc., as a built-in plug.
For longer distance remote operation, the optional extension
cable, OPC-1541 (6 m; connecting between transceiver and
the connection cable), is available, and up to two OPC-1541
can be added.