Icom IC-M505 - Manual (Page 15)

9
3
BASIC OPERATION
3
■ Call channel programming
You can program the call channel with your most often-used
channels in each channel group for quick recall.
q While pushing and holding
[H/L], push [DIAL•DUAL•
GRP] one or more times to
select the desired channel
group (INT, USA, ATIS or
DSC) to be programmed.
w Push [16•C] for 1 sec. to
select the call channel of
the selected channel group.
• “C CA AL LL L” and call channel
number appear.
e Push [16•C] again for 3 sec.
(until a long beep changes
to 2 short beeps) to enter
call channel programming.
• Channel number starts blink-
ing.
r Rotate [CHANNEL] to se-
lect the desired channel.
t Push [16•C] to program the
displayed channel as the
call channel.
• Push [CLR] to cancel.
• The channel number stops
blinking.
25W 25W INT INT
DUP DUP
TAG TAG
34 34°34.506N 34.506N
123 123°23.236W 23.236W
UTC UTC 12 12:00 :00 INTL INTL
25W 25W INT INT CALL CALL
TAG TAG
34 34°34.506N 34.506N
123 123°23.236W 23.236W
UTC UTC 12 12:00 :00 CALLING CALLING
25W 25W INT INT CALL CALL
TAG TAG
34 34°34.506N 34.506N
123 123°23.236W 23.236W
UTC UTC 12 12:00 :00 CALLING CALLING
25W 25W INT INT CALL CALL
DUP DUP
TAG TAG
34 34°34.506N 34.506N
123 123°23.236W 23.236W
UTC UTC 12 12:00 :00 INTL INTL
25W 25W INT INT CALL CALL
DUP DUP
TAG TAG
34 34°34.506N 34.506N
123 123°23.236W 23.236W
UTC UTC 12 12:00 :00 INTL INTL