Icom IC-F60V - Manual (Page 29)

23
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
e Release [PTT] to receive.
• The RX voice message is recorded.
r Push [Playback/Rec] again to stop recording.
• “ ” stops blinking.
• The recording operation automatically stops after the following: the
recording memory is full, pushing any key but [PTT], or transmitting
a single tone.
Playing back:
The recorded voice messages are played back with [Playback] or
[Playback/Rec].
• “ ” appears on the function display when the unplayed message is in
the recording memory.
➥ Push [Playback] or [Playback/Rec] to playback the recorded
message in sequence starting with the latest one.
• Push [CH Up] or [CH Down] to select the desired message.
• A short beep is emitted after playing back each message.
• A long beep is emitted after playing back all messages.
• During playback mode, “
” appears when the unplayed message
is played back, or “ ” disappears when the played message is
played back.
• “ ” disappears after playing back the unplayed message for the
specified time period.
NOTE: You can transmit the recording message with [PTT] while
playing back the message.
Deleting the message:
➥ While playing back the message, push and hold [Playback] or
[Playback/Rec] for 1 sec. to delete the playing back message.
➥ While pushing and holding [P0] and [CH Up], turn power ON to
delete all messages in the recording memory.
! IC-F50V_F60V_0.qxd 07.8.6 10:36 AM Page 23 (1,1)