Icom IC-F60V - Manual (Page 19)

13
2
PANEL DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
COMPANDER KEY
Push to turn the compander function ON and OFF.
The compander function reduces noise components from the trans-
mitting audio to provide clearer communication.
USER SET MODE KEY
➥ Push and hold to enter user set mode.
• While in user set mode, push this key to select an item, and push
[CH Up]/[CH Down] to change the value or condition.
➥ Push and hold this key again to exit user set mode.
• User set mode is also available via the ‘Power ON function’. Please
refer to p. 20 also.
PLAYBACK KEY (p. 23)
➥ Push to playback the recorded messages in sequence, starting
with the latest one.
• A short beep is emitted after playing back each message.
• A long beep is emitted after playing back all messages.
• An error beep is emitted when there are no messages in the mem-
ory.
➥ While playing back the message, push and hold for 1 sec. to
delete the selected message.
PLAYBACK/REC KEY (pgs. 22, 23)
➥ Push to playback the recorded messages in sequence, starting
with the latest one.
• A short beep is emitted after playing back each message.
• A long beep is emitted after playing back all messages.
• “NO REC” is displayed when no message is in the memory.
➥ Push and hold for 1 sec. to start recording. Push again to stop
recording.
➥ While playing back the message, push and hold for 1 sec. to
delete the selected message.
! IC-F50V_F60V_0.qxd 07.8.6 10:36 AM Page 13 (1,1)