Intel GA-8I915P - Manual (Page 13)

Hardware Installation - 13 -
English
1-3-2 Installation of the Heatsink
Fig.1
Please apply an even layer of heatsink paste on
the surface of the installed CPU.
The heatsink may adhere to the CPU as a result of hardening of the heatsink paste.To prevent
such an occurrence, it is suggested that either thermal tape rather than heat sink paste be used
for heat dissipation or using extreme care when removing the heatsink.
Fig. 6
Finally, please attach the power connector of the
heatsink to the CPU fan header located on the
motherboard.
Fig. 3
Place the heatsink atop the CPU and m ake sure
the push pins aim to the pin hole on the
m otherboard.Pressing down the push pins
diagonally.
Fig. 2
(Turning the push pin along the direction of arrow
is to rem ove the heatsink, on the contrary, is to
install.)
Please note the direction of arrow sign on the m ale
push pin doesn't face inwards before installation.
(This instruction is only for Intel boxed fan)
Fig. 4
Please make sure the Male and Female push pin
are join ed closely . (fo r de tailed insta llation
instructions, please refer to the heatsink installation
section of the user manual)
Fig. 5
Please check the back of m otherboard after
installing. If the push pin is inserted as the picture,
the installation is com plete.
Male Push P in
Female P ush Pin
The top of Female P ush P in