IBM Aptiva 2142 User Manual
IBM Computers
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Notices
- Preface
- General Information
- Chapter Description
- Product Description
- Hardware Interfaces
- Refresh Rates and Monitor Frequencies
- Power-On Password, CMOS Reset
- Flash (BIOS) Update Procedure
- Amplifier Card BIOS
- Setup Utility
- Using Power Management Utilities
- POST Error History
- System Memory
- Specifications
- Operating Requirements
- Special Tools
- Check Procedures
- Diagnostic Aids
- Repair Information
- Parts/Test Point Locations
- System Board Layout—Type A-1
- System Board Locations—Type A-1
- Pentium MMX Processor Speed—Type A-1
- System Board Layout—Type A-2
- System Board Locations—Type A-2
- Processor Bus Factor—Type A-2
- Factory-Installed Modem Card
- Hard Disk Drive Jumper Settings
- CD/DVD-ROM Drive Jumper Settings
- Zip Drive
- Detachable Monitor I/O Signal Cable Connector Test
- Media Console Cable
- System Board Connector Specifications
- Safety Inspection Guide
- Parts Catalog
- Assemblies (Service Level A)
- Assembly 1: Machine Type 2140 System Unit -Exterior (
- Assembly 2: Machine Type 2140 System Unit -Interior (
- Assembly 3: Machine Type 2142 System Unit -Exterior (
- Assembly 4: Machine Type 2142 System Unit -Interior (
- Assembly 5: Diskette, Hard Disk Drives, and Zip
- Assembly 6: Media Console (Type 2142)
- Assembly 7: CD/DVD-ROM Drive, Modem, and TV
- Assembly 8: Monitor and Power Cord (Linecord)
- Assembly 9: Keyboard and Mouse
- Assembly 10: Software
- Part Number Index
- Assemblies (Service Level A)
- Appendix A. Online Support Information
- Appendix B. Model/Monitor Configurations
- Index