InFocus 760 - Manual (Page 38)

Maintenance
LitePro 760 User’s Guide 29
6. Using the cloth, unplug the old bulb from its socket as shown
below. Be very careful not to touch surfaces that may still be hot.
Do not touch the bulbs with your bare fingers. Always
hold them with their plastic bag or a clean cloth. The
natural oil on your skin concentrates the heat and may
destroy the bulbs.
7. Keeping it in its plastic bag, remove one of the replacement bulbs
from the box.
8. Without forcing it, insert the bulb all the way into the socket. Be
sure to insert the bulb straight into the socket; do not tip it up or
down.
9. Slide the lamp changer to the other side.
10. Replace the other bulb if necessary. Be sure not to touch it with
your bare fingers.
• Save the box. You may need it later to pack the bulbs for
shipping.
11. Close the lamp door.
Never operate the LitePro with the lamp door open or removed.
This disrupts the airflow, causing it to overheat.
!
WARNING VORSICHT
ATTENTION
LAMP
AND MET
AL
PAR TS MA
Y BE HOT
GLÜHBIRNE UND FLÄCHE
KANN NOCH HEISS SEIN
LA LAMPE ET
LES PIECES
MET ALLIQUES PEUVENT ETRE ENCORE CHAUDES
LAMP:
ANSI-EVD 36V 400W
RECOMMENDED LAMP
- OSRAM HLX 64663
Osprey.bk Page 29 Monday, December 11, 2000 1:38 PM