InFocus 760 - Manual (Page 33)

Using the LitePro 760
24 LitePro 760 User’s Guide
Reset
When you select Reset, the LitePro changes all the adjustments you
made back to the factory defaults. These adjustments are reset:
Switching Projection Lamps
The LitePro was shipped with two projection lamps. To avoid
breaking during shipping, they are not installed in the LitePro at the
factory. You must install them before you can use the LitePro. Refer to
the “Read Me First” document that was shipped with your LitePro.
“Replacing the Projection Lamps” on page 28 also describes this
procedure.
When both lamps are installed in the LitePro, only one is used at a
time. The other is available as a spare for when the active lamp fails.
The average lamp life is 50 hours per lamp.
To switch from the active lamp to the spare lamp:
• Gently slide the lamp changer knob to the other side of the
projector as shown here.
• position • brightness
• contrast • sync
• red, green and blue • colors
• track • inverse
Osprey.bk Page 24 Monday, December 11, 2000 1:38 PM