Using the dhcp address settings, Using, Dhcp – IBM PROJECTOR C400 User Manual
Page 47: Address, Settings
The
factory
default
is
set
to
DHCP
for
the
projector.
You
can
see
the
current
IP
address
in
the
Information
menu.
You
can
change
the
settings
in
the
Network
Setting
menu.
To
access
the
Network
Setting
menu,
follow
the
steps
below:
1.
Press
the
Menu
button
to
open
the
main
menu.
2.
Press
the
cursor
left/right
button
to
move
to
the
Information
menu.
3.
Press
the
cursor
up/down
button
to
move
to
Network
Setting
in
the
Information
menu.
4.
Press
the
Enter
button
to
access
the
Network
Setting
menu.
The
Netowrk
Setting
menu
is
shown
below.
Using
the
DHCP
address
settings
Set
the
IP
Setting
to
DHCP
if
you
are
using
a
DHCP
server
that
will
assign
an
IP
address
to
the
projector.
Chapter
6.
Remote
network
operation
6-5