Impex EVE-890 - Manual (Page 11)

STEP 6 (See Diagram 6)
A.) Place the Backrest Board (#32) onto the Backrest Supports. Secure it with four M6 x 2
1/8” Hex Bolts (#50) and ؽ” Washers (#49).
B.) Place the Seat (#34) onto the Seat Incline Support. Secure it with four M6 x 5/8” Hex
Bolts (#53) and Ø ½” Washers (#49). Insert a L-shaped Pin (#41) to lock the Seat in
desired Incline position.
C.) Insert three Foam Tubes (#37) halfway through the holes on the Leg Developer and
the Main Seat Support. Push six Foam Rolls (#38) onto the Tubes from both ends.
Plug six Foam Roll End Caps (#43) into the Tubes from each end.
D.) Attach the Olympic Sleeve (#55) onto the weight post on the Leg Developer. Secure it
with the M8 x ½” Allen Screw (#16). Attach a Spring Clip (#29) to the Sleeve.
DIAGRAM 6
10