Impex MWM-1840 - Manual (Page 18)

STEP 7 (See Diagram 7)
A.) Attach one Swivel Pulley Bracket (#17) to the open bracket on the back of Vertical
Frame (#4). Secure it with one M10 x 2 ½” Allen Bolt (#76), two Ø ¾” Washers (#91),
and one M10 Aircraft Nut (#97). Do not over tighten the Nut and Bolt. Make sure the
Swivel Pulley Bracket can swivel freely.
B.) Repeat Procedure A to install the other Swivel Pulley Bracket on the other side.
C.) Attach a Front Press Handle (#12) to the Left & Right Butterfly (#9 & #10). Secure each
Handle with one M8 x ¾” Allen Bolt (#80) and Ø 5/8 x ½” Curved Washer (#93).
D.) Attach the Backrest Board (#32) to Vertical Frame. Secure it with twoM8 x 2 1/8” Allen
Bolts (#79) and two Ø 5/8” Washers (#90).
E.) Attach the Seat Pad (#33) to Seat Support (#5). Secure it with four M8 x 5/8” Allen Bolts
(#78) and four Ø 5/8” Washers (#90).
DIAGRAM 7
17