Impex MWM-1840 - Manual (Page 16)

STEP 6 (See Diagram 6)
A.) Attach the Left Dip Support (#28) into Right Dip Support (#27) behind the Power Station
Vertical Frame (#26).
B.) Attach the holes on the bracket of Left & Right Dip Support to the hole on the Vertical
Frame. Align the holes. Secure the Left & Right Dip Support, and the Vertical Frame
together with one M10 x 4 7/8” Hex Bolt (#86), one Ø 1” Washers (#92), one Ø ¾” Washer
(#91), and one M10 Aircraft Nut (#97). Do not over tighten the Nuts and Bolts. Make
sure the Left and Right Dip Support are able to move up freely.
C.) Secure the Left & Right Dip Support together with two M10 x 2 ½” Allen Bolts (#76), two Ø
¾” x 1 1/8” Curved Washers (#95), and two M10 Aircraft Nuts (#97).
D.) When doing Chin-up exercise, fold up the Left & Right Dip Support. Insert the 4” Power
Station Lock Pin (#62) through the holes on Right Dip Support into the open slot on the
back of Power Station Vertical Frame to hold up both Dip Supports in position.
15