Impex MWM-1840 - Manual (Page 14)

STEP 5 (See Diagram 5)
A.) Attach the Front Press Base (#8) to the Upper Frame (#1). Secure it with one 8 ½” Front Press
Axle (#19), two Ø 1” Large Washers (#96), and two M10 Aircraft Nuts (#97). Do not over tighten
the Nuts.
B.) Insert the axle on the Left Butterfly (#9) through the open hole on Front Press Base from bottom.
Secure it with one Ø 1” Large Washer (#96) and one M10 Aircraft Nuts (#97). Do not over
tighten the Nut. Push one Large Foam Roll (#37) onto the Left Butterfly.
C.) Repeat Procedure B to install the Right Butterfly (#10).
D.) Insert the two Butterfly Lock Pins (#60) through the holes on Front Press Base into holes on
Butterfly to lock the Butterflies for Front Press exercise.
E.) Pull out the Butterfly Lock Pins and insert into the other open holes on the Front Press Base for
Butterfly exercise.
F.) Attach Left & Right Chin-up Support (#29 & #30) to Power Station Vertical Frame (#26) from each
side.
G.) Secure them together with one M10 x 2 3/8” Allen Bolt (#82) from front, two Ø ¾” Washers (#91),
and one M10 Aircraft Nut (#97). Secure them together with two M10 x 4” Allen Bolts (#83) from
side, four Ø ¾” Washers (#91), and two M10 Aircraft Nuts (#97).
13