MITSUBISHI ELECTRIC WD-62628 User Manual
Page 95
Chapter 7. Troubleshooting
95
Sound
Symptom
Suggested Solution
1.
There is no sound even when the volume is
turned up.
• Check audio source in Device Menu.
• Check to see if the MUTE button is on.
• The TV’s “Listen to:” setting may be set to SAP.
• Check that the “TV Speakers” setting is On in the Audio/Video menu.
2.
The sound does not match the screen
picture.
• NetCommand® is set up incorrectly.
• The TV’s “Listen to:” setting may be set to SAP.
• If using stereo or A/V receiver speakers, check their input selection.
• If using stereo or A/V receiver, check that AUDIO OUTPUT on TV’s back
panel is connected to the A/V receiver.
3.
The A/V Receiver is the selected audio
source but there is no sound.
• Check to see if the A/V Receiver power is turned on. After the power is
turned on, redisplay the Device Selection menu and press ENTER to allow
NetCommand to correctly select the A/V Receiver input.
• Verify the connections and NetCommand setup for the A/V receiver and the
desired source device, if any.
From the NetCommand menu, select Review. Check the Review screen to
see if the A/V Receiver inputs and device listed correspond to the physical
connections on the A/V Receiver. If they do not match, either change the
physical connections or change the NetCommand setup. To change the
NetCommand setup, make the audio source the TV speakers and select a
source other than the one you want to change. Next select the Change option
on the Edit NetCommand menu to change the A/V receiver input for the
device on the Connection screen.
Indicators
Symptom
Suggested Solution
1.
Lamp indicator light is a constant red.
Turn the TV off for at least 2 minutes. Turn back on. If light is
still red, the lamp has failed. Replace it. See Appendix H for
lamp replacement information.
2.
Lamp indicator light is a constant yellow.
Lamp may fail soon. Purchase a new lamp. See Appendix H for
lamp replacement information.
3.
Lamp indicator light is a flashing yellow.
Lamp cover door is open or lamp cartridge is not secure. See
Appendix H for lamp replacement information.
4.
Status indicator light is a constant yellow.
Room temperature has exceeded proper levels. Cool the room.
5.
Status indicator light is a constant/flashing red.
Service is required. Contact your dealer or a Mitsubishi
Authorized Service Center to arrange for a service evaluation.
Listings of Mitsubishi Authorized Service locations can be
obtained from our web site, www.mitsubishi-tv.com or by
calling 1-800-332-2119.