MITSUBISHI ELECTRIC WD-62628 - Manual (Page 67)

Chapter 5. TV Menu Operations 67
Setup Menu
After memorizing channels, the channels in memory
can be accessed in ascending or descending order by
pressing CH or . Select the Channel Menu to access
further channel-editing features, such as channel add or
delete, channel name, and SQV custom favorite channel
memories.
When you use a CableCARD™, the complete list of
available channels is provided through the CableCARD.
As a result, the Ant-1 channel-memorization options are
not available and are shown grayed out on the screen.
In the TV Guide On Screen® system, the channels
displayed and the order in which they are displayed in
the Guide is independent of the channel-memorization
process. Refer to the TV Guide On Screen Interactive
Program Guide User’s Manual for detailed instructions
on editing channels shown in this guide.
Clock
Figure 9
You may choose to manually or automatically set
the clock that your TV will use for recording or timer
functions.
Manual
To manually set the clock, you need to select the
current time, current date, time zone for your area and
the Daylight Savings time setting.
Figure 9. Time Menu, Setting the Clock Manually
Time
Press ADJUST or repeatedly to slowly select the
hour or press and hold to quickly select the hour. Press
ENTER to move to the minutes options. Press ADJUST
or to select minutes.
Date
Press ADJUST or to select the correct date.
Setup Menu
Figure 8
Figure 8. Setup Menu
Language
Display the on-screen menus in either English or Spanish
(Español). The first time you powered on your TV, you
were requested to select an on-screen-menu language.
If you choose to change the selection, all menu text will
immediately switch to the language of your choice.
To listen to audio in other languages (when available), see
the section of this Owner’s Guide covering audio settings.
Memorize Channels
For Antenna 1 (Main) or Antenna 2 (Aux)
To start channel memorization, first select an input
according to the table below.
Input Condition
Ant-1 Air When connected to an indoor/
outdoor antenna
Ant-2 Air
Ant-1 Cable
When connected to direct cable
Ant-2 Cable
Press ENTER to start the automatic channel-memorization
process. The memorization process is started separately
for each antenna selection.
During the memorization process, all possible channels
on the selected antenna are scanned twice. Analog
channels are scanned first and then the process is
repeated for digital channels.
To stop the automatic channel-memorization process
before it completes, press CANCEL. Channels
memorized before you pressed CANCEL are retained in
memory. If you start the memorization process again, all
previously memorized channels for the selected antenna
input are erased and the process starts over from the
beginning.