Motorola POWERBROADBAND T2-2500 - Manual (Page 28)

Installation Steps
Motorola, Inc. 549453-001-00-a Page 28 of 51
E E n n a a b b l l e e l l i i n n e e p p o o w w e e r r
Login to the mT2 switch using the web UI and HTTP or telnet.
Determine which port is being installed
From the telnet CLI, enter this command:
show bridge address
The MAC address of your PC will appear along with the connected line.
Enable line power
From the telnet CLI, enter this command:
interface dsl power enable portx (enable only the port being installing)
F F i i n n i i s s h h t t h h e e i i n n s s t t a a l l l l a a t t i i o o n n
Remove the 12V regulated power supply. If the correct port is enabled for line power, the WallPlate will reset and
operate from in-line power.
Test the system by connecting to the Internet service provider or other test equipment.