Motorola POWERBROADBAND T2-2500 - Manual (Page 25)

Installation Steps
Motorola, Inc. 549453-001-00-a Page 25 of 51
C C o o n n f f i i g g u u r r e e m m T T 2 2 E E t t h h e e r r n n e e t t X X D D S S w w i i t t c c h h
Initial configuration should be done connected to one of the Ethernet ports on the upstream side of the switch.
Login using a serial console connection, telnet or HTTP. Note the default IP address of the unit if using a network
login for the initial configuration. Default IP: 192.168.1.3
Enter these commands at the system prompt:
Login with default username and password
Username: admin
Password:
Assign IP address to unit
ip config ip-address 192.168.20.2 mask 255.255.255.0 gateway 192.168.20.1
Enable Ethernet ports
interface Ethernet enable eth2
system reboot
Enable all High Speed DSL ports
interface dsl enable port(1-25)
Configure all High Speed DSL ports
interface dsl config port(1-25) max-down 100 max-up 10
Enable remote Ethernet port 1 of each WallPlate
interface remote enable port(1-25)-1