MITSUBISHI ELECTRIC MDT402S User Manual
Page 12
1-12
English-11
English
Stand
Thumbscrews
Speaker terminal
How to use the attached speaker plug
Standard cable
Speaker plug
Striped wire of standard cable
is put into the speaker plug with
pushing lever, like a current
connector.
Fixed cable and speaker plug.
Insert the fixed cable and speaker plug to the speaker terminal.
13. When using external speakers
We recommend using the optional speakers designed for the
MDT402S / MDT461S.
The external speaker terminals of the MDT402S / MDT461S may
be connected with the speaker plug of a mainframe sound speaker.
It this case, please exchange the lead connector of a mainframe
sound speaker for an attached speaker plug.
10. Recommended Adjustment
To reduce the risk of “image persistence”, please adjust the
following items based on the application being used.
“SCREEN SAVER” (See page 24), “SIDE BORDER COLOR”
(See page 24), “DATE & TIME” (See page 28), “SCHEDULE”
(See page 28).
11. When the monitor is installed in the
portrait position
•
Remove the stands (feet).
•
Left edge should be the upper edge from front view.
12. Installing and removing stand
How to install stand
1. Please turn monitor off.
2. Place stand onto monitor with the long ends of the feet in
front of the monitor.
3. After inserting stand in guide block, fasten thumbscrews
on both sides of the monitor.
How to remove the stand
1. Spread the protective sheet on the flat surface, such as
a desk.
2. Place monitor on the protective sheet.
3. Remove thumbscrews with a screwdriver or with your
fingers and place them in a safe place for reuse.
NOTE: Place stand onto monitor so that the long ends of
the feet are in the front.