Metz 40 TK 81 - Manual (Page 19)

19
4.6 First-Time Settings
9. Deleting a single station: select the station to be deleted with the cursor key and press the red key to delete it.
10. Deleting several contiguous stations: select the first station you want to delete and press the green key. Then
select the last station you want to delete and press the yellow key.
Press the blue key to delete the entire block of stations.
11. When you are finished, press the MENU key ቩ to exit from the "Delete stations" window.
Changing the station names
If your TFT monitor can determine the station name from the TV signal, this name is saved at the selected pro-
gramme position. If the station name cannot be determined, the number of the programme position is saved in the
programme position (e.g. PR02).
To change the saved station names, proceed as follows:
• Use the cursor key
̄ or ̆ to select the menu item "Name".
• Press the cursor key ̈ to select the first character of the name.
• Use the cursor keys ̄ or ̆ to scroll through the character set until the desired character appears at the selected
character position.
• Press the cursor key ̈ to move to the next character of the name.
• Repeat the above three steps until you have entered the desired name.
Note that the name may not be longer than five characters.
PC mode
Selecting the signal input
• Press the PC key on the remote control to switch on your monitor.
• Press the MENU key on the remote control to open the TV menu.
The menu item "INPUTS" is coloured.
• In the sub-menu "SOURCE", select the appropriate signal input [PC (RGB) or PC (DVI)].