3 keys and functions of the remote control – Metz 40 TK 81 User Manual

Page 10

3.3 Keys and Functions of the Remote Control

Programming the remote control for the individual devices

Before you can control your AV devices with the remote control, you must enter a three-digit code number in each
of the various operating levels of the remote control.
• TV (TV set)

The TV control level is already programmed for this Metz TV set. No other code can be entered.

• VCR1 (video recorder 1)

VCR 2 (video recorder 2)
DVD player
HiFi (amplifier, tuner, tape deck, etc.)
The remote control must be programmed with the appropriate code numbers, as shown in the code list.

See the factory settings and the code list at the end of these operating instructions.

Programming the codes for VCR and DVD

After execution of the steps a). . . c), you have about 15 seconds to enter the code. After this,
the TV automatically returns to the TV level.

Use the Select key ቱ to select the desired operating level. The LED for the selected level lights.

Press and hold the keys

und --/- on the remote control until the LED blinks twice.

Enter the desired code (see the code list) with the numeric keys. If the code is accepted, the LED again
blinks twice. If you have entered an invalid code, the LED lights once for about 2 seconds.

Programming the codes for CD player, tuner and tape deck

After execution of the steps a). . . c), you have about 15 seconds to enter the code. After this,
the TV automatically returns to the TV level.

Use the Select key ቱ to select the desired operating level. The LED for the selected level lights.

Press and release the

key and then press and hold the key:

--/-

for a CD player
for a tuner (radio)

M/S

for a tape deck (cassette player)

until the LED blinks twice.

Enter the desired code (see the code list) with the numeric keys. If the code is accepted, the LED again
blinks twice. If you have entered an invalid code, the LED lights once for about 2 seconds.

Programming the code for a HiFi amplifier

After execution of the steps a). . . c), you have about 15 seconds to enter the code. After this,
the TV automatically returns to the TV level.

Use the Select key ቱ to select the HiFi operating level. The HiFi LED lights.

Press and release the

key and then press and hold the M/S key until the LED blinks twice.

Press the --/- key. The LED blinks once.

Enter the desired code (see the code list) with the numeric keys. If the code is accepted, the LED again blinks
twice. If you have entered an invalid code, the LED lights once for about 2 seconds.

Searching for the code

Proceed as described above for VCR, DVD, CD, tuner, tape deck up to the point where the code number is to be
entered. Now enter "001" as the code for the search operation. The LED then blinks twice as an acknowledge-
ment of the input. Press and hold the Search key (which depends on the operating level; see the table) until the
search stops or the TV is switched off (a STOP or OFF command is automatically generated every 1.5 seconds).
Release the Search key and press the Select key ቱ to confirm the selection (the code which was found is saved).
After completion of the search, or after all code numbers have been interrogated, the related LED blinks five times.

☞