Metz 40 TK 81 - Manual (Page 14)

4.3 Connecting and Switching On
Connecting (see the picture on page 8 for an overview of the connections)
☞
Insert the mains cable into the input socket on the monitor and plug the other end into an outlet socket.
• Cable outlet or terrestrial antenna
If you have a cable outlet or a terrestrial antenna,
connect it to the socket ANTENNA.
• Satellite receiver
If you have a satellite receiver, use a SCART cable
to connect it to the socket SCART 1 or SCART 2.
• PC
To connect your PC to the TFT monitor, use the PC DVI-I socket. If your PC
has an analogue VGA output, use the enclosed cable (DVI-I to 15-pin HD-
Sub) to connect it to the monitor.
On some older PC graphic cards, pin 9 of the connector may be
blanked off. If this is the case, please contact your local dealer.
Preparation
• Remote control
☞
Open the battery compartment on the back of the remote control and insert the two batteries supplied with the
monitor (type LR03 Micro AAA). Observe the battery polarity shown on the bottom of the battery compart-
ment. Close the battery compartment again.
Switching on
☞
Set the mains switch on the back of the monitor to the
position "I". The monitor is now in standby mode
and can be switched on with the remote control.
• Cable outlet or terrestrial antenna
☞
Switch on the monitor by pressing the TV key or one
of the numeric keys on the remote control.
14
Ǽ
RK 14
T V AV P C
– / – – F M / S