Mustek TM KB3100 User Manual

Page 50

- 3 - 10

CHAP.

COMMAND LISTING IN SCAN-CODE EDITING MODE

ESC -- leading code to enter scan code of any key after it into key-content, except

“ESC” + “F” for utility version since 2.15.xx

ESC-F -- leading code of arbitrary release code for utility version since 2.15.xx.

usually used to release “CTL”, “ALT” or “SHF”.

F1 -- get help on command list of ASCII- code editing mode

F5 -- enter view mode

F8 -- enter view mode

F10 -- enter view mode

BkSp -- delete the character to the left of cursor

Ins -- toggle insert/overwrite status for editing (default = insert)

Del -- delete the character where cursor stays or the last character

Home -- go to first position within the key definition

End -- go to last position within the key definition

PgUp -- go to one page less in cyclic manner

PgDn -- go to one page next in cyclic manner

Up arrow -- move cursor to one row up in cyclic manner and enter view mode

Down arrow -- move cursor to one row down in cyclic manner and enter view mode

Left arrow -- move cursor to one character left within the key definition

Right arrow -- move cursor to one character right within the key definition

Alt-A -- enter view mode

Alt-D -- enter time delay mark into the key-content

Alt-M -- enter a multi-level shift marker into the key-content

Alt-N -- enter view mode

Alt-S -- enter a multi-level separator between definitions of different levels.

Alt-X -- enter view mode

Alt-27 -- work like “ESC” as the leading code for scan codes.

Alt-8 -- enter a “BkSp” into the key-content

Ctl-C -- immediately terminates the programming utility.

any other displayable key stoke -- will be taken as an input in scan-code format.

any other non-displayable key stroke -- will have no influence