Magellan Maestro 4370 - Manual (Page 13)

Please note that the swivel mount supplied with the Magellan Maestro may be different then the one
shown in this document.
Securing the Swivel Mount to the Dashboard
Remove the protective tape from the back of the adhesive disk. Apply the disk with the adhesive side
towards the dashboard. Maintain pressure on the disk for 5 minutes to allow it to set in place. Allow the
disk 24 hours to cure before continuing.
Make sure that the lever at the base of the adjustable mount is in the up position. Place the base of the
swivel mount firmly over the adhesive disk. Push the lever at the base of the swivel mount all the way
down until it snaps in place. Carefully let go of the assembly, making sure that it is securely mounted.
Attaching the Magellan Maestro to the Cradle
Align the tabs on the cradle to the indents on the bottom of the Magellan Maestro. Swivel the cradle up so
that it is flush against the back of the receiver and snap it into place.
Adjusting the Mount for Optimum Viewing
Loosen the adjustment locking knobs and position the Magellan Maestro for optimum viewing. Once set,
tighten the locking knobs. (Never attempt to adjust the mount while driving.)
Connecting Power
Plug the end of the vehicle power adapter into a 12V DC vehicle power receptacle. Connect the other end
of the cable to the Magellan Maestro’s USB connector as shown.
If there is power at the receptacle, the Magellan Maestro will power on. (Note: some vehicles apply power
to the vehicle power receptacle only when the ignition is on.)
Connecting the Traffic Antenna
Attach the FM antenna connector to the receiver just above the power connector.
4