MicroNet Technology SP3367A - Manual (Page 14)

13
2.4 Hardware installation
This section describes how to connect and configure the ADSL router.
1) Connect the ADSL line
Connect the router directly to the wall jack using the included ADSL
RJ-11 telephone cable.
2) Connect a workstation to the Router's LAN port
Use Ethernet RJ-45 cable to connect computer or expend Ethernet
network.
3) Connect the power adapter to the Router
Connect the power adapter to the port labeled POWER on the rear
panel of router.
4) Connect all cables to the Network
The procedure for connecting cables differs depending on whether or
not your telephone equipment is connected to a POTS splitter. The next
section explains ADSL splitter and describes the configuration in
networks of ADSL over POTS and ADSL over ISDN.