Motorola GP68 - Manual (Page 34)

Model ST-865M3 SmarTrunk II ™ Logic Board
34
4.2.2 Primary Code
The Primary Code consists of a four digit number that is
contained in the SmarTrunk II digital transmission. Any
four digit number from 0000 to 9999 may be used. See
Section 2 (Operating Modes) before assigning the Pri-
mary Code.
To program the Primary Code: Enter the program code
12 followed by the # key, then the Primary Code fol-
lowed by the # key.
Example: To program a unit’s Primary Code to 1234
press: 1 2 # 1 2 3 4 #.
4.2.3 Secondary Code
The Secondary Code consists of a four digit number
contained in the SmarTrunk II digital transmission. Any
four digit number from 0000 to 9999 may be used.
See Section 2 (Operating Modes) before assigning the
Secondary Code.
To program a Secondary Code: Enter the program code
13 followed by the # key, then the Secondary Code
followed by the # key.
Example: To program a unit’s Secondary Code to
1200 press: 1 3 # 1 2 0 0 #.
4.2.4 Priority Subscriber Enable
Enabling this program code makes a subscriber unit a
Priority Subscriber. A Priority Subscriber can pre-empt
calls currently in progress on the trunking system.
Note: Care must be exercised when using this fea-
ture. A priority subscriber can terminate im-
portant calls of other subscribers. If too many
priority subscribers are enabled, the priority
subscribers themselves will be competing for
trunking channels. Additional trunking chan-
nels should be installed if the system is heavily
loaded.