Motorola GP68 - Manual (Page 20)

Model ST-865M3 SmarTrunk II TM Logic Board
20
The System Operator/Manager activates a subscriber (individual or group)
by programming the ST-852M SmarTrunk II Controller. This activation
involves assigning a Subscriber ID Number, Paging Code Number,
operational type and a number of other controller parameters. As
previously stated, each piece of SmarTrunk II subscriber equipment is
capable of "over the air" operation with two Paging Code Numbers. These
are the numbers that will be programmed into the subscriber equipment.
An individual Subscriber ID Number and associated Paging Code are
numbers assigned to one subscriber. The subscriber may be called as an
individual by other subscribers or from the landline. Calls made by and
to the individual subscriber are accounted for and recorded by the ST-
852M SmarTrunk II controller.
A group Subscriber ID Number and associated Paging Code are numbers
assigned to more than one subscriber. These grouped subscribers will
receive a common alert if the Subscriber ID Number is called from another
radio subscriber or from the landline. This signalling is commonly used
for dispatch/fleet radio operation. Calls made by and to any subscriber in
the group are accounted for and recorded by the ST-852M SmarTrunk II
controller.
Example #1: If a subscriber is only a radio telephone user, the Pri-
mary Code is programmed for the Paging Code associ-
ated with the Subscribers ID Number. When the sub-
scriber has no need for radio group calling, the Sec-
ondary Code should be programmed with the same
number as the Primary Code. In this case, the
SmarTrunk II subscriber equipment operates similar to
single line telephone.
Example #2: If a subscriber has a requirement to operate radio tele-
phone and radio group calling, the individual Paging
Code is assigned to the Primary Code and the group
Paging Code assigned to the Secondary code. The op-
erator of this equipment, can receive and initiate indi-
vidual calls to and from other subscribers and the
landline. Additionally, this equipment can be contacted
as part of the radio group.